Environmental Simulate High And Low Temperature Test Chamber Brake Pads Hardener Test Machine
Mainly used for national defense industry, aviation industry, automotive parts, electronic parts, plastic industry, food industry, pharmaceutical industry, and related product research and development, quality management engineering test specification.
1. The international famous brand imported compressor and refrigeration accessories are adopted to ensure the stability of the refrigeration system.
2. Can show the cause of the fault, easy to eliminate.
3. Special air supply circulation design, good uniformity of temperature and humidity distribution.
4. Full series of imported microcomputer controller, color touch screen, Chinese and English voice display.
5. Super silent design, effectively reduce the noise of equipment operation.
6. Multiple safety protection, refrigerant high voltage protection, compressor overload protection, current overload protection, overtemperature protection, leakage protection.
||Environmental simulate test chamber
|Inner box volume
||70* 90*80 CM
||100* 180* 103 CM
|Heat up time
|Pull Down time
||±1°C/ on: ±3% RH
||SUS# 304stainless steel plate
||Cooling or SUS# 304 Stainless steel plate
1. External coating: box RAL7047, decorative color RAL5015 for control area
2. The internal experiment space is composed of 304 stainless steel plates.All joints are seamlessly welded and vapor free.
3. Pressure balance valve: the box body is equipped with a pressure balance system, equipped with a shaking valve, when the internal pressure of the box body and the outside pressure difference when the automatic balance.
3. Air handling system: it is attached to the back wall in the box body, which contains the following components: cold and heat exchanger, heating exchanger, humidification into the pipeline, dehumidification coil, heat-regulated air recirculation fan, temperature and humidity sensor.The thermally regulated air flows into the air handling unit and is treated by each of the components mentioned above before entering the test chamber.
4. Moisture removal system: Use the flat pipe ring connected to the refrigeration system to achieve.
5. Internal air circulation: the external extended shaft motor drives the internal fan to realize forced circulation convection.
6. Humidification system: it is completed by low-pressure steam generator with electronic heater, equipped with water softener and heating pipe, which can realize automatic water replenishing.
· To simulate test environment with different temperature and humidity
· Cyclic test includes climatic conditions: holding test, cooling-off test, heating-up test,moistening test and drying test…
· Cable port with flexible silicone plug for cable routing to provide the condition of test unit under operation
· Uncover test unit weakness in a short-term test with accelerated time effect
3.CHAMBER DESIGN FEATURES
· High performance and quiet operation (68 dBA)
· Space-saving designed for flush installation to wall
· Full thermal break around doorframe
· One 50mm diameter cable port o left, with flexible silicone plug
· Direct water supply connection for continuous operation
· Accurate wet/dry-bulb humidity measurement system for easy maintain
· PIC controller for test chamber
· Step types include: ramp, soak, jump, auto-start, and end
· RS-232 interface to connect computer for output